Substituir o termostato do distribuidor de pó
Selecione o modelo da sua impressora
(Padrão: Universal)
Escolha o seu modelo no menu suspenso abaixo.
Termostato de reposição para o agitador de pó da XINFLYING
Modelo compatível: Universal
Tutorial em vídeo
Replace the powder shaker temperature controller and restore its original terminal wiring. Record the terminal positions before disconnecting the wires.
Applicable model: General. Required items: compatible temperature controller, screwdriver, and phone for recording connections.
Passo 1. Desconecte e solte o controlador
1.1 Switch off and unplug the powder shaker. Access the rear of the temperature controller and photograph every terminal connection before removal.
1.2 Loosen the controller terminal screws and disconnect its wires. Keep the wire positions identified for reinstallation (See Figure 1.1, left).
1.3 Press the retaining clips at the upper and lower edges of the controller, then slide the old controller out of the panel opening (See Figure 1.1, right).
Step 2. Fit the Replacement and Restore the Wiring
2.1 Insert the compatible replacement controller into the original panel opening and engage its retaining clips so it is securely mounted (See Figure 2.1, left).
2.2 Reconnect each wire to its original corresponding terminal using the recorded photograph. Tighten the terminal screws and check that the wires are secure (See Figure 2.1, right).
2.3 Refit any service covers opened for access before reconnecting the powder shaker power supply.
Se você for não tenho certeza sobre alguma etapa, entre em contato com o Equipe de Suporte Técnico da XINFLYING para obter ajuda.
© 2026 Equipe Técnica da XINFLYING. Todos os direitos reservados.
Não reproduza nem modifique este documento sem autorização.
Para obter suporte, entre em contato com: [email protected] | www.xin-flying.com