Sostituzione e controllo della testina di stampa
Seleziona il modello della tua stampante
(Impostazione predefinita: Universale)
Scegli il modello dal menu a tendina qui sotto.
XINFLYING Replace and Debug Printhead
Modello compatibile: Universale
Tutorial video
Replace the printhead and its ribbon cables, restore the damper connections, and correct mechanical alignment using a printed test pattern.
Applicable model: General. Required items: compatible printhead and ribbon cables, screwdriver, dust-free cloth, acetate cloth tape, and printer control software.
Step 1. Remove the Old Printhead
1.1 Switch off and unplug the printer. Remove the carriage cover to expose the printhead assembly (See Figure 1.1, left).
1.2 Place dust-free cloth on both sides of the printhead to catch ink. Lift off the dampers, keeping their ink tubes connected and their positions identified (See Figure 1.1, right).
1.3 Remove the four printhead fixing screws. Lift the old printhead enough to access its cable connections, supporting it without straining the cables (See Figure 1.2, left).
1.4 Remove the tape securing the ribbon cable connections, then pull the cables straight from their sockets. Retain the cable labels as connection references (See Figure 1.2, right).
Step 2. Connect and Install the New Printhead
2.1 Inspect the replacement ribbon cables for oxidation or damage. Use compatible, undamaged cables; defective cables can damage the printhead or headboard.
2.2 Connect the labeled ribbon cables to the corresponding sockets on the new printhead. Match each label to its position, such as left upper to left upper and right lower to right lower. Align the exposed cable contacts with the socket contacts (See Figure 2.1, left).
2.3 Secure the cable connections with acetate cloth tape as shown, without pulling the cables out of position (See Figure 2.1, right).
2.4 Handle the new printhead by its body without touching the nozzle surface. Place it in the original mounting position and reinstall the four fixing screws.
2.5 Keep dust-free cloth around the printhead while reinstalling the dampers in their original positions. Fully seat each damper, then remove the protective cloth and check the cable connections (See Figure 2.2).
Step 3. Check and Correct the Printhead Alignment
3.1 Clear the work area and power on the printer. Click Check in the printer control software to print a test pattern. Inspect the lines for visible offset or misalignment (See Figure 3.1, left).
3.2 Switch off and unplug the printer before adjustment. Loosen the four printhead fixing screws without removing them (See Figure 3.1, right).
3.3 Use the two adjustment screws on the illustrated mount to correct the printhead vertical alignment. Adjust a small amount according to the printed deviation (See Figure 3.2).
3.4 Tighten the two fixing screws at opposite corners to hold the printhead for the next test (See Figure 3.3).
Step 4. Retest and Finish the Installation
4.1 Power on the printer and click Check again to print the test pattern. Compare the lines with the previous result. If misalignment remains, switch off and unplug the printer before repeating the adjustment (See Figure 4.1, left).
4.2 Once the printed lines align correctly, switch off and unplug the printer. Tighten all printhead fixing screws to secure the final position (See Figure 4.1, right).
4.3 Refit and secure the carriage cover, keeping the cables and ink tubes clear of its edges (See Figure 4.2).
Se sei non sono sicuro di quale sia il passo da compiere, si prega di contattare il Team di assistenza tecnica XINFLYING per ricevere assistenza.
© 2026 Team tecnico di XINFLYING. Tutti i diritti riservati.
È vietato riprodurre o modificare il presente documento senza autorizzazione.
Per assistenza, si prega di contattare: [email protected] | www.xin-flying.com